How to start the ride-on power trowel machine

Before starting the car polishing machine, please ensure that you have read the operation manual and taken necessary safety measures. The following are common startup steps:

###Startup steps:
1. * * Security check**
-Ensure that there are no obstacles around the machine and the operating area is safe.
-Check if the fuel, oil, and coolant are sufficient.
-Confirm that the disc is securely installed without any looseness.

2. * * Start preparation**
-Place the polishing machine on a flat surface.
-Open the fuel valve (if any).
-Adjust the throttle control lever to the "start" or "low speed" position.

3. * * Start the engine**
-Electric start: Insert the key, turn to the "start" position, and release the key after the engine starts.
-Pulling rope start: Hold the rope handle, pull quickly, and slowly release the rope after the engine starts.

4. * * Preheating**
-After starting, let the engine run at low speed for 1-2 minutes, preheat before proceeding with the operation.

5. * * Adjust the speed**
-Adjust the throttle control lever as needed and select the appropriate speed.

###Attention:
-* * Fuel * *: Use recommended fuel and avoid using inferior fuel.
-* * Engine oil * *: Regularly check and replace the engine oil.
-Operating environment: Ensure that the ground is flat and free of debris.
-* * Personal protection * *: Wear protective equipment such as helmets and gloves.

###Shutdown steps:
1. Lower the throttle and let the engine run at low speed for 1-2 minutes.
2. Turn off the engine.
3. Close the fuel valve (if any).

###Tip:
-Regularly maintain the machine to ensure it is in good condition.
-If unable to start, check the fuel, spark plugs, etc., and contact professionals if necessary.

By following the above steps, it can be ensured that the car wiping machine starts up normally and runs safely.